Includes:

• Jigs to locate and drill both GSPEED V1-C1 &TGH-V3 chassis for lower motor mount hole
• Will require (3) M3 x 8 button head screws for spur housing

Directions:

• Remove forward motor mount
• Remove (3) M3 screws from spur shaft housing
• Remove spur shaft
• Flip spur shaft 180°
• Reassemble motor mount and install (3) M3 x 8 button head screws (in place of M3 x 8 cap screws) into spur shaft housing

GSPEED V1-C1

• Use supplied triangular shaped jig
• Install jig using one bolt in existing shock hoop hole
• Jig should follow contour of shock hoop
• Drill thru jig at open hole into shock hoop with M3 or .125" drill bit
• Remove jig
• Reinstall motor mount in correct orientation with spur facing forward

GSPEED THG-V3

• Use supplied "L" shaped jig
• Install jig using 2 bolts in existing shock hoop hole
• Jig should follow contour of shock hoop
• Drill thru jig at open hole into shock hoop with M3 or .125" drill bit
• Remove jig
• Reinstall motor mount om correct orientation with spur facing forward

Team Garage Hack Transfer Case:

• Remove transfer case plates & gears
• Remove bearings from plates if not already removed
• For O.D. option only; flip transfer case plates
• Reinstall bearings into rear plate
• Install rear plate into case housing
• Install rear input gear and shaft
• Move front output gear and shaft from right side of case to left side of case
• Install rear output shaft and gear into remaining position
• Re-install front plate