The Team Associated RC10 B6.2D Team 1/10 2wd Electric Buggy Kit carries on the AE tradition of domination. The B6.2D includes both Layback and Laydown transmission assemblies to fine tune mass balance to track conditions; add to that the addition of +1 Ackermann plates and gull wing suspension arms to tune the steering for razor sharp feel and control. Combine this with high end features like an easy-access differential, outer rear hinge pins captured with bolt head and locknut for increased durability, symmetric rear arms that can be flipped to allow an in-between rear shock mounting position, and a revised slipper assembly. The setups and tuning parts are interchangeable between the B6.2 and B6.2D configurations, and offer the speed, durability and lineage expected of a true champion. NOTE: Painted body, electronics, wheels and tires shown in photos are for illustrative purposes only and are not included. See needed to complete list below for a full list of items required to complete the model. Features: Symmetric 73mm rear arms with improved geometry and stiffness can be flipped to allow an in-between rear shock mounting position Rear hub assembly with modular vertical ball stud camber link mount and axle height adjustment Bolt-on +1 steering block arms for improved steering response Body design with lower center of mass Clear body and wing included Front wing mount and front wing included Outer rear hinge pins captured with bolt head and lock nut for increased durability Updated left side rail with motor fan mount (fan not included) 67mm CVA bones for reduced bone plunge and minimized friction at drive pin 13g aluminum chassis weight included for improved mass balance and easy electronics removal 7mm aluminum clamping wheel hexes Ball differential included Both Layback and Laydown Stealth™ transmission assemblies included to fine tune mass balance to track conditions Differential height adjustment with 0, 1, 2, and 3mm inserts included 7075-T6 aluminum arm mounts with optimized roll center positions and inserts for tuning anti-squat and toe adjustments Heavy-duty V2 routed graphite front shock tower with tower guard Heavy-duty V2 routed graphite rear tower, standard V2 12mm Big Bore threaded aluminum shock with X-rings Machined shock pistons for more precise fit and smoother operation V2 springs for a more reactive and nimble feel Aluminum rear ballstud mount with three link position options Lightweight aluminum one-piece top shaft and gear Factory Team upgraded ball bearing kit included (now oiled instead of greased for less drag) Specifications: Scale: 1:10 Power: Electric Length: 387mm (15.2") Width: Varies* Weight: 758g (1.67 lbs) (chassis only) Wheelbase: Varies* Transmission Ratio: 2.60:1 Needed to Complete: 1:10 scale electric motor Electronic speed control 7.4V, 7.6V LiPo, 6.6V LiFe with "shorty" battery dimensions Battery charger 2-channel surface transmitter 2-channel receiver Steering servo Polycarbonate-specific spray paint for body 1:10 scale off-road wheels and tires Pinion gear Other helpful items: Silicone shock fluid, Silicone diff fluid, FT body scissors (#1737), FT body reamer (#1499), FT hex/nut driver set (#1519), CA tire adhesive (#1597), Hobby knife, Needle nose pliers, Wire cutters, Soldering iron, Calipers or a precision ruler